ZippoCollector.ru

Today I bought a Zippo, the wheel was initially hard (which is understandable) but an hour later, just do a spinning stopped, took out the spring, without of course easy turns, and just do it in any.

What to do? FLINT replace or ...? forward advice.

Flint - shit IMHO. I encountered such that Kresalo go crazy because of the crappy flint ...

hohol writes:

well, then it comes out when the flint is very soft and well Kresalo like bogged down in it, especially as a new annealing and Kresalo more evil! try to change the flint!

I would say the non-uniform, that is found in the soft mass of hard inclusions, Kresalo cutting into the "clay" and stumbles upon a solid "stone" and stands perfectly still ..

you dear man did not say the most important thing - the condition of flint

and then you know if it was from a triangular stub then it will be worse than the wedge shoe rail.

Well, logically. do you think, apart from flint than there can be a stud? right, a smart man, one can see - not for anything.

about soft flint - do not agree.

set right now flint IMCO. believe me, softer nowhere. new wheel, flint soft - leaving a greater force for rotating Kresalo. Well, a shower of sparks like Boeing pezdanulsya - so fun.

and more. ketayskie flints not take it. is not necessary. make them bad people. I would even say buggers. but I will not say that they are homosexuals. because the owner of our cabal promised a separate topic about motherfuckers. but the topic is not. therefore I say - motherfuckers.

with respect, parting and brush your Y.

More often the case that when flint brand new - you need a very decent effort, so that the wheel krutnut, even with brand flints it happens occasionally, but it was then when he (flint) on both sides still virgin - something like the factory oplyvov seen. I'm usually on the jeans several times wipe, sparks "from Boeing" and expel all becomes normal. Well, so, of course, be sure to check out - not stuck to that, and then the wheel itself what filth and stupidity irrepressible Chipped possible, and this is crappy.

Shall insert 5 cents. Sometimes it happens that seizes a brand new flint. To avoid this, the maximum loosen the spring (but do not remove the screw completely) and pochirkayte bit, then tighten the spring to the end. Thus flint pritretsya to the wheel at a comfortable angle for both of them and the problem will disappear.

Sometimes such crap when new flint or vice versa at the end. Usually in the opposite direction a couple of times krutanesh wheel and all - then fine spinning.